ECU Tuning & Evora Power Upgrade
ECU calibration with TPW Engineering, and our dyno-proven Evora 400 power upgrade: 385 HP stock to 490 HP.
Mapped, not just flashed
In partnership with TPW Engineering, we offer advanced ECU calibration for the Evora and Exige range. This goes well beyond a generic flash: the calibration is developed for each car, so the hardware and software work together for optimum performance.
Request a Tuning QuoteEvora 400 Power Upgrade
We ran this Evora 400 on the rolling road before any work began: 385 HP and 360 lb-ft as standard. With our kit fitted and mapped, it produced 490 HP and 408 lb-ft. The kit combines our exhaust system with an induction kit, set up and mapped on the dyno.
- Stock
- 385 HP360 lb-ft
- With Our Kit
- 490 HP408 lb-ft
- Gain
- +105 HP+48 lb-ft
More Dyno Results
Exige 410
Our exhaust system, a TL intake kit and TPW mapping on the original ECU produced 485 HP and 400 lb-ft.
Exige V6 Performance-Packs
An intake kit, our full exhaust system and a smaller supercharger pulley, all made in the UK, then mapped by one of our trusted partners.
Evora 410
Our complete exhaust system with the TL intake kit we helped develop, followed by mapping on the dyno.
ECU Tuning & Evora Power Questions
- Is it a generic map?
- No. Working with TPW Engineering, each car is calibrated individually and mapped on the dyno, so the hardware and software work together.
- How much power will my car make?
- It depends on the car and the parts fitted. Our Evora 400 went from 385 HP to 490 HP, and an Exige 410 produced 485 HP on its original ECU. Every car is mapped individually, so results vary.
- Do I need an aftermarket ECU?
- Not for these upgrades. The Exige 410 result was achieved with TPW mapping on the original ECU.
- Which cars can you tune?
- We calibrate the Evora and Exige range with TPW Engineering. Tell us about your car and we will advise what is achievable.
Other Upgrades
T304 Stainless & TitaniumExhausts & Fabrication
High-flow exhaust systems hand-built for the Lotus chassis, from T304 stainless and titanium, for the Elise, Exige, Evora and Emira.
Track-Proven Chassis PartsSpitfire Engineering
Uprights, toe link kits and aluminium fuel tanks from Spitfire Engineering, two minutes from our workshop.
Handling & RideSuspension Refresh
Refurbished wishbones, new bushes and ball joints, performance dampers and a bespoke alignment.
One-Off FabricationCarbon Mirrors & Custom Projects
Carbon fibre mirrors for the Elise and Exige, and one-off design and fabrication for your own project.
